Search results

Results 1 to 13 of 13
  1. L

    Lack of Power

    I have a 4 year old Kubota L4400 with 330 hours. Over the last few weeks I have noticed a large drop in power when going up any incline. I have to shift to a low gear or the tractor will come to a complete stop. I cleaned the air filter, that didn't help. I replaced the air filters, that didn't...
  2. L

    installing hydralic pipe inlet

    I have a L4400 and noticed small amounts oil under the tractor. I found one of the hydralic pipes partially crushed causing a small leak around one of the O rings. The part is called the pipe inlet in the hydraulic oil line assembly. My dealer suggested that i replace the pipe which I ordered...
  3. L

    Kawasaki Mule

    I was wondering if I could get some advice. I have just started to look for a UTV for my property. I have 200+ hilly acres about a mile long. I need something for hunting, tree work and occassional rides with my family. I don't need fast but prefer 4 seats. From my research I have found 3...
  4. L

    Adjusting brushhog

    I am not really clear on how to set up my brushhog for cutting. This is my second summer of using it and although it does an OK job I feel I don't always have it set properly. The manual is not that helpful and talks about leveling it from side to side and the front being slightly lower than the...
  5. L

    Underwater

    Yesterday I was mowing around our pond which I have done various times before. To make a very long story short I got stuck with the front end of my 4400 underwater with about 25% of the engine compartment at an angle forward underwater. The engine stalled and I did not restart it. I was able to...
  6. L

    Broken Back Blade

    While grading my road yesterday with my Bota L4400 I hit a stump bending my 7ft Woods back blade. I was able to bend it back but the cutting edge broke in two and there is a crease in the moldboard. I was bummed thinking I would have to replace the whole asssembly but I realized that I may be...
  7. L

    Chains  front chains

    Last winter I got my L4400 with R-4 tires. I use the tractor for everything from mowing to plowing so I felt these tires would be a good compromise. I found that I would get stuck frequently often in shallow ditches and when trying to plow uphill. I got a set of rear chains. I heard many...
  8. L

    oil/hydro filters

    Its time to do my 50 hr service however I cannot figure out what filters I need. The manual just says a kubota filter but I went to TSC. They were not very helpful. They only sell Fram and the book does not list my L4400. Does anyone know how I find out.
  9. L

    Roller pump

    I just bought a 55 gal boom sprayer from TSC. They neglected to tell me that I had to buy the pump separately. I got a Hypro 6500 cast iron. When I got home the manual said not to use roundup or liquid fertilizers with the cast iron, but it does not explain why. Do I have to go back AGAIN and...
  10. L

    Chains  Tire chains

    I just purchased a L4400 with a backblade to plow my 0.8 mile uphill driveway. I have R-4 tires and have a hard time getting up the hill with a foot plus of snow. I was calling around to find some which is almost impossible this time of year and one of the service people told me not to get...
  11. L

    Battery Light

    My L4400 only has 7 hours on it. The battery light won't turn off after the engine is started. It seems to be running fine, but do I have to worry about something? Everything seems to be hooked up right. Alterrnator? Loose wire? I cannot find a diagram anywhere that shows me what everything is...
  12. L

    tipping

    I just got my L4400 a month ago. I know tipping can be a problem if you go across a hill but what about going up and down a hill. I will be using it on trails that are quite steep. Looking at the tractor I have a FEL and a lot of the weight seems to be over the front tires. It would seem to me...
  13. L

    L4400 toolbox

    I just purchased a L4400 which I really love. The only problem is there is no place to stow tools except for a klenex sized toolbox behind the seat. I have found a place for my chainsaw, bungied to the left side if the drivers seat. Does anyone else have ideas of where to put various tools?
Top