Search results

Results 1 to 6 of 6
  1. J

    Bush Hog crazy wheel revisited.......

    OK, I appreciate all the responses I had to my wheel thinking it is a plow. I took a good look at it and discovered that the yoke was bent and re-welded in such a way as to cock the wheel back in the wrong direction. I took the torch to it and cut the weld and straightened the yoke/shaft...
  2. J

    Rotary Cutter  Bush hog crazy wheel....

    Ain't too crazy or may it's too crazy. Anyway it won't pivot...it gets sideways and trys to be a plow. Dang thing will pivot easily by hand when not on the ground. Does the angle look to steep? I'm beginning to think it has the wrong wheel on it. I bought it used. Don't know why the site...
  3. J

    Howard HN Rotovator

    Where can I get a set of tines for a Howard HN Rotovator?
  4. J

    3-Point Hitch  Lower lift arm bent?

    Got a 53 TO 30 pulling a 5 foot bush hog of unknown maker. The BH pulls off to the right (from drivers seat) almost to the outside of the tire. The sway chain is very tight with the left side loose. This, of course, puts the PTO shaft way out of alignment putting undue wear and tear on the...
  5. J

    1981 Troybilt Horse....recoil starter

    My recoil starter has never worked right. I took it apart and cleaned and oiled the mechanism, used loctite on the little bolt and it worked OK for a short while. I took it apart today and it has "grenaded" inside the housing. Its on a 7hp Kohler which starts on the first pull everytime so my...
  6. J

    1981 Troybilt Horse....

    With a Kohler engine. No matter what I do with the "belt engagement lever block" for lack of a better name, it jumps out. The block looks almost new but the detent wheel has some wear and pitting. I am at a total loss....real pain in the back! hehehe. I can get it ajusted where it will stay...
Top