Search results

I have a JD 3039R that has the R4 tires on it. Of all the tractors I've had, none of them have rode as rough as this one. Since most of the "jounce" seems to come from the front, I've been thinking of replacing them with turf tires. I've aired the fronts down with absolutely no change in...

I'd like to bypass the seat switch on my 3039 R. If I hear a noise, I like to get off the tractor and listen to the equipment as it's running. Can't do that now. As it looks to be a simple 2 wire setup, I assume a simple jumper will do the trick. But the pins inside the connector are really...

Thinking of upgrading my 11 year old JD LA 145 to the JD X584 with a 48" deck. The LA 145 is what I call my trim mower. I have a 4 acre lot surrounded by woven wire fence with several buildings and a few trees. Plus several "dead" spots I mow as it's easier than using the Case IH DX-33 in...

I have a 2002 Poulan Pro with a 48" deck and a 26 HP B&S engine that I want to replace due to sporadic heavy smoking and oil usage. The engine is a 446777 077 E1 with about 700 hours on it. I can't seem to find a 26 HP replacement engine that will swap into this mower. I can find a B&S 25 HP...

I'm back with another post on this tractor. The #3 cylinder is dead. Had a guy out here who says the injector pump is not supplying enough pressure to operate the injector on that cylinder. He left the line loose as the engine ran hoping it was air bound. No luck. What would cause this...

I was mowing when the 2005 TC33D suddenly started to sputter for about a minute and then lost power. Barely made it it back in the shop. It would not rev over 1200 RPM. Changed the fuel filter and fired it up where it ran about 30 seconds and then died. Opened the bleeder screw and cranked...

I have a Case-IH DX-33 with 15X19.5 R4 tires. What is a good chain to put on this tractor for the wet heavy snows that we get around here? I have a gravel driveway, but the tractor can't get much traction because the tires will float on the snow and spin. Going uphill with the FEL is...

Actually, I have a DX 33. Same tractor. I have the same problem as referred to in this post: http://www.tractorbynet.com/forums/new-holland-owning-operating/98153-tc33d-rear-pto-shifter.html The rear PTO shift lever is really hard to engage or disengage. But that post is from 2007. Can anyone...

Actually, I have the DX-33. But anyway, I sold the farm but sectioned off 4 acres where I live. I don't need the Case-IH 685 for that small amount of land I have left. But that loader is really handy. What would be a good loader for my DX-33 and how much (roughly) would it cost to put it on...

Ok, so it’s a DX-33. Figure I’d get more responses here. I’ve seen the posts on these tractors blowing the #2 fuse. The one that takes out the starter when it blows. Seems to be a problem in a lot of these tractors. Right now, I stuck a 20 amp fuse to prevent this, but I just don’t feel...

I’m getting ready to get 200 gallons of diesel. This will last me a year. Is it better to add the Power Service to the diesel storage tank or just keep measuring it and pouring it in the tractors when I fill up? I’m not sure if Power Service has a “shelf life” in a storage tank.

Hey all. Does anybody know what the new price of a New Holland 256 Rolabar rake would cost? With or with out the dolly. I’m looking for a used one but prices are all over the map. My local NH dealer closed up shop last year and the other dealers stock the big wheel V rakes. Since the...

Ok, I have the DX-33. Same thing. How do these injector pumps work? Are they strictly gravity fed from the tank? I did the 50 hour service. After changing the fuel filter, the tractor ran about a 15 seconds and died. OK, air in the system. I tried to bleed the injectors. Nothing. Put...

Hey all. I’m looking to buy a 9-foot disc mower to replace my aging sickle mower. So I’m looking for pricing info on the various brands out there. And reliability reports, such as are there certain things that wear out on these types of mowers? How often do you sharpen the blades...

implement-ML-851816-ML- Belongs in Attachments forum

Hey all. I’m thinking of getting a disk mower to replace my aging sickle mower. The disk mower would go on a Case-IH 685 2WD tractor that has around 62 HP. Rear tires are 18.4X30” tires that are loaded. Now then, I see various minimum HP requirements for these mowers. Take the 9-foot...

Getting ready to come up on my 50 hour service. The manual states to use 10W-30 or 15W-40, depending on temperature. But it doesn’t say what type. Am I supposed to run automotive type oil like Pennzoil or a diesel service type oil like Rotella?

Hey all. Looking for an engine heater. I’ve seen the posts on a freeze plug block heater, but the freeze plug on my DX-33 looks to be a pain to get to. So, I got to thinking about a radiator hose heater like on my older tractors. Has anyone installed one of these on their 33 or 29 tractors...

I was at the Case-IH dealer looking for some Hy-tran/Hy-tran plus for a Case-IH 685 tractor. Dealer says that Case-IH no longer makes it. They only have Hy-tran Ultra, which is not compatible with my brakes. So they said. Told me I can only get it through the aftermarket. They have an...

Stopped by a dealer today and priced two FELs. One quote was $5000 for a Bush Hog 2446QT with a 72” bucket and bale spear. The other was $5700 for an Alo Quicke 720 with the same attachments. Both quotes are fully installed. I’d never heard of a Quicke loader until today. The dealer said...

Hey all. Long story short. A friend’s Super A has been sitting in my barn for about 3 years. 2 months ago I sprayed either into it just to see if it would start and it fired up immediately. The throttle worked then but the engine wouldn’t stay running. Yesterday I cleaned the junk out of the...

Hey all. I’ve been thinking about a front end loader. I have a Case-IH DX-33, hydro with no remotes. I also have a Case-IH 2WD 685 with 1 rear remote. I like the idea of the loader on the DX-33 but the lift capacity with a factory loader is less than 900 pounds. But to be honest, the little...

Does anybody have the Big Bee rotary cutter? Any thoughts on it? I’m looking to buy a 6-foot, 3pt rotary cutter for my DX-33 and was going to use it to trim under trees and around fences before I bring out the Case-International 685 and the 10-foot Bush Hog. I’m tired of fighting tree limbs...

Hey all. I’m looking for a 3pt PTO driven seeder. All of the dealers around here have those big 11-bushel seeders, which is also used to spread fertilizer. My father-in-law has an old seeder that probably will only hold about two sacks of seed. It has a square type box and I can pick it up...

I saw on a previous post that the King Kutter tillers only go down so far on one pass and that you have to make two passes to get to the required depth. Is there a tiller that will go down to 6-8” on one pass? Seems kinda wasteful to have to make two passes over all that ground. I’m getting...

Are suitcase weights brand specific? I need some weights for the front of my Case-IH DX-33 and a friend has a several different sets, but said he didn’t think any of them would work as they are for John Deere and Kubota. He told me new suitcase weights are about 3 bucks a pound, so I’m trying...

Is the NH 134 hydraulic oil compatible with the Hy-Tran Ultra oil? The front axle is a little low and I have a lot of the 134. Thanks.

Seems to be more people over here. On my DX 33 (Same as a TC 33DA) the cruise control works sporadically. Is there something I can look for before hauling the tractor to the dealer? I’ve already unplugged the connector down at the lock next to the pedal to check for connection. When you push...

DC 33 DA 72\" Mower Price Check Well, mine is actually a Case DX 33, but I hear they are the same. Went to price a 72” MM rear discharge mower at the Case dealer. He quoted $3600 dollars for the mower. Jeeze that seems way high. Are the NH mowers the exact same? Seems everyone is paying...

Ok, I might have found a DX 33 with 1 hour on it for $12500. Guy won it in a raffle and doesn’t want it. I think that is a pretty good price and I want to put a factory rear discharge MM mower on it. Any idea what one of those cost?

Hey all. I’m looking at (Or going to look when he gets it in) a Case-IH DX 29. I was told this is the same as the NH TC 29. I don’t know the price yet as it is a Saturday and he could not get any info on it. I’m going to look at the DX 29 HST with a MM rear discharge mower. This is what I...

I’m looking for a CUT with a MM rear discharge mower with a HST. The Case-IH dealer thinks the DX 29 will fit the bill. He has none in stock for me to look at, but is willing to bring one in for me to test. Of course he has no prices and can’t get any on a Saturday. So, does anyone else out...

Hey all. After spending a lot of time lurking on this board I have another question. With all the buildings I have to mow around, I’m leaning towards a rear discharge finish mower. Do these mowers do a good job? I have a 72” rear mount Landpride that can throw a rock a long way. If I get a...

Ok, here goes. I posted on another section about trying to replace an old Murry mower that I used to trim around buildings, fences and on hillsides. It has a 46” offset deck that I can stick under fences. It is a super trim mower but it is on its last legs. I also have a 25 horse Poulan Pro...

Hey all. New to this forum but here goes. I have an 11 year old 16.5 horsepower Murry rider that has a 46” deck. This thing is a trimming machine. The deck sticks out a lot on one side and I can stick that deck under woven wire fences, trim around trees and buildings. It takes about one...