Search results

Time for a new seat on the 1920. Would appreciate any feedback from other Ford series 20 owners who purchased an aftermarket seat. Thanks.

Don't use the backhoe very much. Considering purchasing 4 foot cutter to use. For those B26 owners who use a brush cutter, what has been your experience. Thanks for the feedback.

Used the B26 to dig a trench for a 20 foot culvert to divert water under my driveway and spread a load of maintenance gravel. Time to complete these tasks was about 3 hours. Tractor performed flawlessly. Parked tractor for about three months and then tried to start with no success, just a click...

Anyone have a suggestion on an aftermarket 3 point hitch system? Thanks.

Still trying to fix all of the problems with my newly acquired 2013 B26. Tractor idled low and high very good but would stall in forward L, M or H and reverse. My problem was with the seat safety switch. It was just dangling under the seat completely wrapped with electrical tape to close the...

Recently purchased a 2013 B26TLB which comes standard with the loader quick attach. Having trouble releasing the bucket to remove. Loader quick attach handles just won't move to up(Release) position. I am following instructions in the manual. Appears bucket may not have been removed in quite a...

My Stihl 026 has a fuel supply problem. When I pour some fuel directly into the carb, it runs for a few seconds and dies. I have removed the carb, the fuel line, and filter. I plan on purchasing a rebuild kit for the carb and new fuel line and filter. There is another line from the carb that...

I hope some of the 1920 experts in this group will be able to provide some assistance. Over the last two years I have noticed that my coolant level goes down slightly and I have had to add small amounts. The amounts have been increasing. I have found no leaks but have noticed white smoke from...

First I would like to thank all who have posted their FEL snow plow projects. They have been an excellent source of information and ideas, as well as inspiration to start my project. I hope that this post will also add to the knowledge and idea base. The goal of my build will be to fabricate an...

Trying to determine which type of arc welder to buy. Uses are to repair equipment and some fabrication. Have ruled out MIG because most repair work to be done outdoors and with "dirty" metal. Is AC/DC worth the extra cost? Your opinions.

I have been doing the routine maintenance and some repairs on my 1994 1920 since I bought it new. I have decided to check and adjust the valve clearance myself this time around. I have followed this forum for several years now and know there are some 1920 owners out there that are very...

Anyone have any experience with a Scattrack Mini Ex? Am looking at a small 1999 or 2000. Concerned about the ability to get parts and the durability of these mini exs. Any common problems with these machines? Thanks. Ray