Search results

Results 1 to 10 of 10
  1. D

    3 pt stop

    I finally decided to make a stop for my 3 pt on 3515ch. Now, it is a bit rough as the only tools I had were hacksaw, file and drill. I used 1/8" x 1-1/2" aluminum bar stock. I stacked the base pieces together and created a moveable stop piece. The base pieces are ~ 6-1/2" long. I have used to...
  2. D

    Branson Parts

    I know some have swapped out the tier 4 muffler setup for a I think a Stanley muffler. Well, I thought I would see what a 2515 muffler would cost as an alternative to this approach on a 3515 for a what if scenario.... Well that was a short lived thought as the muffler for 2515 is ~$1,200! Does...
  3. D

    Battery terminals

    Thought I would post this as an FYI to check battery terminals. I had an issue when i turned on tractor the tach and temp needles started bouncing around and the hour meter went dead. It was a bad ground and found both battery terminals being eaten through. I honestly ignored them when checking...
  4. D

    3515CH HVAC

    Trying to troubleshoot an HVAC problem. I have been through what service manuals I could find; but I can't find anything in them related to HVAC. I did see that the 20 series service manual has section in it for HVAC. Mine is tier 4 and does not have a dryer. My initial problem was no cold air...
  5. D

    Loader value (BL 150)

    Thought would pass this on. In the past I wondered if I had an issue with loader bleed down, the dealer came out and replaced the original loader value which didn't fix the problem (it appears some loader bleed down can be expected, I had him test a couple of tractors he had on his lot). The...
  6. D

    Loader lift and tilt question

    GM, I am curious has anybody noticed if they have the bucket up in the air that the lift or tilt loses pressure and drops. I have 3515CH with 150 loader. A while back I was loading some scrap material in the bucket and after probably less than 1 hr I hear a noise and the plywood had slid off...
  7. D

    3515ch thermostat

    GM, hope everybody is doing well. I did do some searching around this; but thought I would throw it out here. I have ~75 hrs on the tractor and originally noticed the temp would go up to the 1st mark and drop to cold and would fluctuate a bit; but never getting up to 1st mark. I don't have a way...
  8. D

    540E

    Do you use the 540E? I am thinking of using it for mowing my pasture (very clean and not over 18" high) and was wondering if running 540E at ~1900 rpm would get engine hot enough for the tier4? I have a 6' flail mower.
  9. D

    3515ch

    Good Day, I am new here and have researched this; but wanted to get the experts take. My wife and I recently purchased ~30 AC place that is mainly all mature pasture with some woods and is gently rolling. My main uses for the tractor would be basic upkeep and mowing the pasture if I don't lease...
  10. D

    x1.37HC

    Good Day, I am new here and have researched this; but wanted to get the experts take. My wife and I recently purchased ~30 AC place that is mainly all mature pasture with some woods and is gently rolling. My main uses for the tractor would be basic upkeep and mowing the pasture if I don't lease...
Top