Search results

If you’re charging phone you might as well hold it too. Google up motorcycle phon e mount with charger...

I’m not familiar with your model but many of the smaller LS tractors had a roll pin wear problem on the hydro pedal/lever actuation rod. Pedal moved, rod moved, just not as much as it should.

I thought about a cheaper Jeep/truck but a so happy I went UTV. Convenience and capability make the case for UTV. A rolled over UTV is easy to flip upright, Jeep/truck/tractor means walking back to equipment shed to get recovery tool and another tractor. My UTV has 1500lb cargo capacity, more...

I ”Practiced“ with old seal to get an idea of its pliability. Warmed up with a heat gun, with my hand behind it to insure I didn’t melt it, it was soft and resilient. New seal popped into place easily after warming it up in my hand with heat gun. I slipped piston back into cylinder to make sure...

Thanks all. I didn’t want to remove old seal not knowing if the new teflon seal was elastic enough to stretch into place. I’ll warm everything up and get it done.

It was time to fix steering cylinder leak, disassembly went fine, replacing all the seals and bushings while I’m there. Anyone know how to swap out the seal in the middle of the cylinder rod? Service manual is of little help except saying to replace worn parts. Parts manual shows an O-ring...

I didn’t read the whole thread, but I did see many posts suggesting 200+ amp machines. I’d say get the Lincoln 140. Like you, I have a big stick machine. I added the 110v Lincoln 140 and it handles 90% of my welding. Being 110v make it easy to use in various places. If I’m doing something that...

I have #10 SAE panel mount connectors on most of my equipment. Stuff that doesn’t get used over the winter gets on a trickle charger rotation To keep batteries ready to go...

Plugging backhoe into existing remote works great. Scrap metal catch with rubber washer, riveted in place, to hold remote valve open was simple solution.

Yeah, bungee would be for test purposes. A simple slide latch or flip over lever would be my long term solution.

I wasn’t clear, looking to add hydraulic lines for backhoe. The pictured lines/valve came with tractor, for rear remote (top link, etc) Maybe the easy button is plugging backhoe into current remote valve lines and bungee the valve open?

I see many posts about adding third function valves and many posts about T-ing the loader lines for backhoe hydraulics. Seems like it would be super simple to get feed & return from the pictured block… is there a Kubota or aftermarket part made for this purpose? Or a third function valve that...

I bought my Boomer 24/XJ2025 BECAUSE of the Mitsubishi engine. Same with the Cummins in my Dodge truck. I don’t care about bells and whistles, I just want reliable power.

PTO lever safety?

Boomer doesn’t. Kubota GST has clutch pedal.

Yep. Internet says very light pedal pressure equals “lowest gear” maximum force but mine needs about half pedal to make maximum PSI. With no wheel rotation, light pedal pressure equals low hydraulic PSI, middle pedal equals maximum PSI and at full pedal pressure hydraulic PSI drops off. Does a...

Boomer 24 (Xj2025) I’ve had for about a year. As I venture further from improved surfaces I find tractor won’t climb medium grade in high range and on’t climb steep grade in low range. Tried light, medium & full pedal, mid throttle and full throttle. Tractor just stops forward motion as...

Did you ever resolve this? My Boomer 24 (same machine) will not spin it’s tires going up a steep slope, just slows to a stop.