Search results

My ford 1910 like many old tractors turns over rather slowly when cranking. So I was wondering if I replaced the solenoid if it would make it any faster or does the whole starter need to be replaced? Also if a solenoid would make a difference what size and type would I need? Thanks for any help.

Does anyone know of a spin on fuel filter adapter for a ford 1910?

Got my westendorf ta-111A installed on my 1986 ford 1910. Pretty pleased with it.

Does anyone know where I can get a replacement shifter knob for my ford 1910? SBA398180210 Is the part number. I already purchased two from wengers however only one came in the mail and it was in fact not the knob they had listed. Any help is appreciated.

Is the bolt that I have circled a oil drain for one of these old Kiki diesel injection pumps?

When changing fluids in my ford 1910 does the rear diff have different fluid from the transmission or is it all from the same tank?

I have a ford 1910 with a leaking injection line at the fitting going to the injector, and I’m in need of a replacement. Where could I find one? Part number SBA131506720

I’ve been trying to install a new westendorf loader on my ford 1910 however I can only get the psi above 200 on the diverter block when I put the 3 point hitch lever all the way to the top in the notch area, however once in the notched area the psi will be at 2000. Does anyone have any...

I’ve recently changed my hydraulic fluid and used Delvac tractor fluid however I’m now concerned it may be bad since it is not new holland brand. Has anyone used it or have any knowledge? I used it in my 1986 ford 1910.

Ever since I had the fuel filter changed the 3rd injector has been leaking fuel out of the bolt that holds the fuel line to the injector. I have it as tight as it will go and it still has a slight leak how can I stop the leak? Would the plumbing thread tape work?

I’ve never changed the hydraulic/ gear oil in my ford 1910 since I’ve gotten it I’m thinking it might have a little water contamination but not sure.

I’ve been trying to find a replacement for this bolt for the front axle of my tractor it’s an m18 bolt however I cannot find one with threads as fine

What are these part

Does anyone know of any good ford tractor junkyards around the US? Preferably close to Tennessee but anywhere will do.

I’m looking for a ford 770 or 770a/b and a ford 7108 front loader. Thank you for your help.

Stopped by the local co-op to get the fertilizer wagon and a couple thousand pounds of fertilizer for my sheep fields, the little ford took it like a champ.

I saw a ford 770b loader for sale for $4500 I’m think it’s way over priced any idea what would be fair for one with a bucket

I changed the water pump on my ford 1910 this summer I’ve ran the tractor many hours since but when I used it today I noticed a little bit of coolant had leaked out it appears to have come from what I think may be some type of drain but I’m not sure any help would be appreciated

I’m replacing the fuel filter on my tractor and I saw a kit with a new bowl, filter, o-ring for the bowl but then there is a very small o-ring and a spring what is the spring and small o-ring for

The bowl on my fuel filter housing is leaking after I changed the filter it’s on tight don’t know what would cause it to leak it’s leaking from the threads where it screws on

I have a ford 1910 2wd and I’m wanting a front loader, would it be too much stress on the front axles, I’m not looking to max out lift force trying to pick stuff up just wanting it for some medium to light work

I need help finding a comparable air hose I’ve gone to the parts store and they could not find a hose that would work the normal hose they had would not work because it needs a spring inside to keep it from closing up its 3 inch diameter

I was working on my ford 1910 and had to remove the air filter hose to remove the radiator and I noticed that the inside of the hose, air filter housing after the filter ,and manifold all had a layer of dust I don’t think there is any air leaks and the filter is new is it normal for it to let...

Does anyone know where to find these replacement fuel lines for a ford 1910

Today I ran a disc for several hour and on the way back to my barn the tractor would have a loss of power it would be completely normal but when a small hill came the tractor wouldn’t lug down it would just drop rpm’s slowly like you were decreasing the throttle and when you tried to push the...

I have a ford 1910 and it needs coolant but I can’t find what type it needs any body know what it might use?

I have a ford 1910 and I had heard about changing the oil in the injection pump I had no idea that was a thing any advice

I’ve always wondered what it is everyone I’ve asked doesn’t really know

Does anyone know where to find an exact replacement for wheels on a 2wd Ford 1910 I need the front and rear wheels for a restoration

I have a case farmall 95 with a westendorf front loader when I turn the tractor off the loader will leak down completely in a few minutes without load on it it will also leak slowly while while the tractor is on if it’s holding something

Is it safe to put radiator flush liquid to flush my radiator or will it cause problems

What brand of rotary cutter have you had the best luck out of or prefer the most

Has anyone on here used a no till planter before and if so how well did it work

Everyone who has or is currently restoring your tractor how did it turn out and what problems did you have

I have a small 32hp ford 1910 2wd that I use to bush hog about 15 acres of well kept fields with and use a finishing mower on about 3 acres that is cut weekly. what tires would be best to still give me good traction without being bad on grass? I would like to buy firestones since the originals...

What is the best diesel fuel additive for an old tractor?

Anyone know where to find a roof to fit a ford 1910

I have a ford 1910 and originally I had a 6 ft standard duty bush hog that was bought new with the tractor it weighed too much for the tractor and made the front wheels super light so I switched it for a 5 ft kodiak and it can pick up to the max height without any issues at idle and there’s no...

I am looking into buying a 9125p but I haven’t found where it specifies it’s speed I’m only curious because I have to drive my tractor down the road to get to my different properties

Any one know where I can find new hoses for this bale unroller

Interested to hear other owners opinions and experiences

How many fellow members have repainted their tractor

I have a Ford 1910 and I have a disc at my farm that requires remotes to lift it however I do not have remotes on my tractor would it be possible to add a rear remote

I have a Ford 1910 and I’m wanting to use a subsoiler to loosen some hard packed soil on my hunting lease would a 1910 be strong enough to pull a single shank?

I have a Ford 1910 and I was curious if it is a fuel pump that you have to change the oil in if it is how do you change the oil

These are what hold the floor boards on the round piece is rubber and it appears to be attached to the metal piece on the side

Does anyone know where to find a hose like this

If I were to use biodiesel in my tractor what are the pros/cons

Is there anyway to get the moisture out and seal the gauges again?

I recently changed the exhaust on my 1910 because the original had rusted off I’ve noticed that it dings like a bell while the tractor is running everything is 100% tight and it has a gasket is there anyway to stop this or is it just normal

I’ve always wondered what the best brand is out of the old international’s,Fords,orJohn Deere

My dad is looking at Ford 6610s and 7610s what are the different between the normal and series two

I’m repainting my tractor with krylon farm implement Ford blue does the catalyst hardener actually make a difference

How many hours should I expect to get out of my Ford 1910

I have a Ford 1910 with a 1.7 3 cylinder and I was wondering if you could put the turbo from a John Deere 1050 on it since they are comparable motors

I’m repainting my Ford 1910 and I’m wanting to know what the best high quality paint is

Is it possible to increase the power on a tractor?if so what’s the best way to do it

I’m wanting to know which transmission my Ford 1910 has there’s two types a synchromesh transmission and a non synchronized how do I need to check

My Ford 1910 is very light in the front with the 5 foot bush hog on it I ordered 5 50 pound weights that are the same as the originals will that be enough to make a difference

Does anyone know where to find a white roof for a Ford 1910

I’ve gotten a Ford 1910 recently and I would like to know what all I should check and replace to restore it back to it’s original power and condition it only has 820 original hours on it.the only part I’ve replaced on it is a seal on the hydraulic piston which made a huge difference on the...

I’ve recently come across one of these Taylor 5 row planters and I can’t wait to use it does anyone have any tips for it

Has anyone used any Ford blue rust oleum farm implement paint I’m wanting to repaint my tractor and I’m wonder if it’s worth using

Has anyone used sea foam in the engine oil of a tractor

Does anyone know where to find a washer like this

The lights on my Ford 1910 will go dim and then bright when the engine strains or if your starting to drive is there anyway to fix that

Does anyone have experience with a Ford 770 loader on a 1910 I would like to get one but I’m not sure if it’s worth it

Does anyone have experience with the Firestone super all traction 2 r-1 I would like to put them on my Ford 1910

I’m trying to restore my Ford 1910 and Ive been trying to remove the hydraulic control handle that you use to control the up and down on the 3 point hitch but it’s rusted on I’ve removed the pin that holds it in place but it won’t budge I’m out of ideas on how to get it off... I’d love to hear...