Ballast Brush guard and ballast
- Thread starter bbse
- Start date
- Views: 4234
oosik
Epic Contributor
I noticed - they went from icon size to text. I can open them but its probably because the originals are loaded on my computer. It could be that the combination of the four pics is just to large - each pic is 1.5MB to 1.7MB. It will take me a little bit but I will use my software and resize them and see if that helps. Back in 30.
oosik
Epic Contributor
OK - back like a dirty sock. The four pics have been resized to 500kb.
View attachment 567224 View attachment 567225 View attachment 567226 View attachment 567227
Must have just been that the originals were too big.
View attachment 567224 View attachment 567225 View attachment 567226 View attachment 567227
Must have just been that the originals were too big.
OP
bbse
Platinum Member
That is nice work. Don't know if I could build one that nice. But I am sure I can make something for weight. That doesn't have to be pretty.
oosik
Epic Contributor
bbse - come on man. Its not that hard. All I did was tack expanded metal onto the existing OEM guard. Really it was tedious, not hard. Every one of the contact points had to be tacked on and I did it in a zig-zag pattern - in case there was going to be any heat expansion - and there wasn't any. The "tongue" was made up, off the guard, on a flat table top and then tacked on in place.
I initially thought to paint the tongue RED - but as I thought about it - - that would be just too much.
I initially thought to paint the tongue RED - but as I thought about it - - that would be just too much.
