ssgp2
Bronze Member
I have the Titan 1606C, and it has been okay. I did have an issue with the gear box u-joint being put in backwards from the dealer. Then the lower seal started leaking. I called them, in Decatur, Tn. and they sent me a whole new drive system. Gearbox, PTO shaft with clutch at no charge. They had no problem paying the dealer to swap it out, but this particular dealer takes weeks to get to stuff after you drop it off, so I said I would do it myself.
I do wish it had taller sides to increase to volume, though. I will say I'm rather rough though because of the type of material i cut and the areas I go into, and it is comparable to my Rhino 172. Not trying to sell Titan, just giving my experience as an owner.
I do wish it had taller sides to increase to volume, though. I will say I'm rather rough though because of the type of material i cut and the areas I go into, and it is comparable to my Rhino 172. Not trying to sell Titan, just giving my experience as an owner.
