Cab on a BX24

[bird1968]

I got my old cab from the BX22, (Curtis, which I had to modify for the BX22) & remodified it to fit the BX24. I bit more work this time around.

I'm not sure if anyone is making a factory one for a BX24 yet, but here my version.

Hope this helps someone.

Richard

 

[art]

looks pretty shiney! The same cab companies still fit the same way!

 

[bx24]

Looks great. Share some more pics (especially where it meets the engine cowling - both inside and out)

 

[Grrrr]

If that shiny silver plate on the front was orange, it would look almost factory. Good job

 

[Volfandt]

I like that diamond plate. How's the grapple project going?

 

[Dog Lover]

Bird, Looks great..You should go in business!

 

[peterc38]

I got my old cab from the BX22, (Curtis, which I had to modify for the BX22) & remodified it to fit the BX24. I bit more work this time around.

I'm not sure if anyone is making a factory one for a BX24 yet, but here my version.

Hope this helps someone.

Richard

Wow, looks great!

CabDepot makes them for BX series up to BX 23.

Sims Cab Depot - Kubota Sub-Compact Tractor Cab Enclosure - Models: BX1500, BX1800, BX1830, BX22, BX2200, BX2230, and BX23

Under "upcoming products" They state that one will be available this year for BX24 (TBD 2007)

 

[Riptide23]

I've often wondered if it would be possible to replace my BX 23 ROPS with a BX2250 ROPS bar for the winter, so as to allow the use of a cab, since the backhoe would be off for winter anyway...

Nice work Richard. You must have a cool workshop...

Pat

 

[bird1968]

If that shiny silver plate on the front was orange, it would look almost factory. Good job

I may have to paint it; it's hard to take a picture & the deers are always getting in the way!

Here a pic, with the door on.

 

[bird1968]

I'm not 100% finish, I need to pickup a few rubber molding, which will seal it all up.