hazards/4 ways not working????

   / hazards/4 ways not working???? #1  
Joined
Sep 29, 2008
Messages
12
Location
Middleton,MI
Tractor
Bobcat toolcat
going to check the fuses in the AM but they just quit working were working fine and just quit while they were on and working any ideas besides the fuses, any help would be great.
 
   / hazards/4 ways not working???? #2  
I'd check the fuse first, then the dash switch.

DEWFPO
 
   / hazards/4 ways not working????
  • Thread Starter
#3  
I checked the fuses and all were fine, but I noticed the front right turn signal bulb is out do you think that would cause it not to work, the blinkers don't work either
 
   / hazards/4 ways not working???? #4  
My flashers stopped working last year. Was a simple fix. The flasher control unit is a small, silver metal can that's attached to the wiring harness under the dash. It's not too hard to find...it's near the center of the dash. IIRC, it's a standard, two-prong device that you can buy almost anywhere (e.g. NAPA, Schucks, Checker, Autozone,...).
 

Tractor & Equipment Auctions

UNUSED FUTURE XJ7T 7T 46" HYD THUMB CLAMP (A57193)
UNUSED FUTURE XJ7T...
4 Cubic Yard Dumpster (A55851)
4 Cubic Yard...
2012 Vermeer V500LEHD Vacuum T/A Towable Trailer (A55973)
2012 Vermeer...
2007 CATERPILLAR 725 OFF ROAD DUMP TRUCK (A52707)
2007 CATERPILLAR...
UNUSED FUTURE FT-SE61 61" HYD SWEEPER (A57193)
UNUSED FUTURE...
Nissan Forklift (A55973)
Nissan Forklift...
 
Top