LT1050 Oil Change HELP !!!
- Thread starter hdsanders
- Start date
- Views: 4077
-
- Tags
- cub cadet lt1050
OldMachinist
Platinum Member
The change oil indicator will flash for a while after the hour meter reaches the milestone that turned it on. The below is from the LT1050 manual
The LCD will alternately flash the recorded hours and CHG and OIL for five minutes after every 50 hrs of recorded operation. The maintenance interval lasts for two hours(from 50-52, 100-102, 150-152, etc). The LCD will flash as described above for five minutes every time the tractor engine has been started during the maintenance interval.
By not starting do you mean it doesn't turn over or does it turn and not start?
The LCD will alternately flash the recorded hours and CHG and OIL for five minutes after every 50 hrs of recorded operation. The maintenance interval lasts for two hours(from 50-52, 100-102, 150-152, etc). The LCD will flash as described above for five minutes every time the tractor engine has been started during the maintenance interval.
By not starting do you mean it doesn't turn over or does it turn and not start?
lexus114
Member
Is the oil level full?? This engine may have the protection that it will not start if not full with oil. Also,check to make sure you didn`t (by mistake) pull any wires loose while changing the oil.
JTKub
Veteran Member
And make sure you are in the seat, with the parking brake set and the PTO off to satisfy the ignition circuit.
Joel
Joel
dqdave1
Veteran Member
Did you disconnect spark plug wire/s when you changed oil as a safety measure?
