Rear work light stock wiring

JD 4520 · Nov 27, 2020

On my 4066R, I have installed the JD rear work lights, however, I can only locate the stock wire for the right side. I have not been able to locate the left side (rear) wire. I know it should be purple and black, so I know what I am looking for, but just can’t locate it. Any suggestions?

oosik · Nov 28, 2020

On my 2009 Kubota M6040 there was only one hot lead - on the right side. Wonder if that is the same case on your JD.

beenthere · Nov 28, 2020

Only one hot lead for the work lights on my 4300, and suspect that may also be true for the OP. The switch for power only has one position and not a right and left position for two work lights. Hope these ideas help.

RoyJackson · Nov 28, 2020

You may have to wire them together using a "Y" connector. I did that for wiring two LED work lights on my Gator. Both lights are operated by one switch.
The cab tractors (4xxx series) do have four work lights...two forward, two aft...all controlled by one switch.
Another thought is asking you local Deere dealer service department the best way to wire them...