Box Scraper Spacing and pins for clevis style cat 1 lift arm mount

[Nick350]

I am currently working out the design for a new 3pt mount on an old frontier box blade I have. The previous owner had chopped and rewelded on the mount before bending it again.

I know originally it had the clevis style lower link mounts but I don稚 know the correct spacing width for the lift arm to slide between or the correct type of pin to use for this assembly.

Any help will be greatly appreciated

 

[bcp]

Use the right hand diagram.



Bruce

 

[Nick350]

You could not have given me a better reference!

Thanks!