tough paint

   / tough paint #61  
If you have about an extra $60k for a good Downdraft booth, and use it properly, it can really make a difference.

I have panted a lot of parts, cars, trucks, boats, buses, trailers, outside. As you know, under the right conditions, you can get a really nice job.
 
   / tough paint #62  
I think my 1/yer hobby tractor collecting paint jobs will likely be staying out in the open unless the lottery comes in.. :)

soundguy
 
   / tough paint #63  
seems like every time I try to paint outside it will rain, flood, famine and locusts will fly out of no where and land right in the middle of the best looking panel :eek: ;) anyhow I've painted a LOT of stuff outside and or in a pole barn areas. I had a dang BIG ole spider drop down and crawl across the hood of a nice car back a while ago... it made it from almost dead center all way down to the hood ornament.. Go figure...

The last thing I painted with Liquid Paint was my Dump Wagon I built form scratch back in 02 or so. seen here are some pics dump trailer pictures by WPSPIKER - Photobucket it still looks pretty good despite a couple hundred tons of wet gravel sand wood and STUFF. The inside is starting to rust a bit now mostly due to scratches and setting with wood in it for last year on and off. the wood/bark is worse than gravel I think for increasing rust.

Mark
 
   / tough paint #64  
The "swimmers" ALWAYS end up in the middle of the hood. :thumbsup:
 
   / tough paint #65  
yep.. on a big piece you can't section and repaint.. like a side panel that has joints you can tape up..

soundguy
 

Tractor & Equipment Auctions

NEW HOLLAND 105 WORKMASTER MFWD TRACTOR (A52708)
NEW HOLLAND 105...
Fast 9613N 1300 Gallon Sprayer (A57148)
Fast 9613N 1300...
2013 CATERPILLAR 259B3 SKID STEER (A52709)
2013 CATERPILLAR...
DRAFTING TABLE, METAL MOTOR STAND (A58374)
DRAFTING TABLE...
New/Unused CFG Industrial MH12RX Mini Excavator (A57453)
New/Unused CFG...
2020 Husqvarna YTH22V46 46in Riding Mower (A56859)
2020 Husqvarna...
 
Top