Oil & Fuel when I get this thing turned upright

[knucklehead1]

Got too close to the edge today..always knew it would happen. Does anyone know what I should do before I attempt to start it again?

 

[dcyrilc]

Check all fluids is the only thing which comes to mind right off the bat.

I'm assuming that you weren't hurt at all. Well, except maybe your pride.

 

[Patches]

#1 Get it upright #2 Pull the glow plugs, if you have them; if not pull the injectors and spin the engine over several times to clear any fuel/lube oil from the intake stream and cylinders.#3 Check the oil for adequate level, put all the stuff you removed back and fire 'er up

 

[beeforty]

Glad you survived:thumbsup: This something I personally haven't had to deal with, but probably make sure no oil or other fluids got in the cylinders, don't want to bend rods make sure radiator is ok and check the battery for loss also. Good luck with it.

 

[moored4]

All of the above are good! But first a clean set of shorts are in order!!:laughing:
glad your OK!!:thumbsup::thumbsup:

PS! Just saw your a new member! Welcome!!

 

[groundcover]

Then look into ROPS and a seat belt ! Lucky you didn't meet St Peter !

 

[deepNdirt]

Glade to hear you're OK:thumbsup: I must ask though! it looks like more than one roll over to have wound up down there if so? you might want to be looking at some other issue's Like bent lift arms, bent steering wheel,,the exhaust pipe, etc,etc, what Implement did you have on the tractor?

 

[kebo]

Wow, that's a heck of a first post by a new member, glad you survived the accident to post! Like already suggested, do look at getting a ROPS installed.

 

[Scooby074]

"when I get this thing turned upright"


Go buy a lottery ticket!!!

 

[dex3361]

Welcome to TBN and I am glad you didnt get hurt in the rollover. Kubota has a reduced price ROPS program and add a seat belt along with it. Please consider looking into the program here is the link Kubota ROPS Program