I've just built a pto leaf blower for my Mitts 160.I used a old furnace blower,a simple angle iron mount and a shaft I fabbed.It works great,with my 3 speed pto I'm spinning it a little faster then the motor that was with it.I put a small sheet metal shoot to aim the air flow down a little and to the back.The leaves on my road get shot about 20 feet back in the bush,were they belong.I put 6 inch legs on it with quick pins,so it stands off the ground when I remove it from the 3point hitch and some 1/4" screen over the openings to keep the leaves out from the wheel.I've tried to post pic's on this site but can't figure it out,I have posted pic's on yahoos Mitsubishi tractors group,look for Sam's Mitts in muskoka .Build one you will love it ,beats rakeing.