yarg
Silver Member
Hello Gentelmen,
I built a well drilling machine. It is hydraulic and all is great,,,,but? The cylinder for raising and lowering the mast does not operate right. Here are the issues :
1. Cylinder is double acting.
2. Valve is log splitter type.
3. Hoses are 1/2 inch.
4. Actuating valve causes engine stall and sever cylinder speed= very jerky mast action close to damage if not fixed.
Tried 1/16 orifice hole on one line but the same thing happened.
Your thoughts?
Thanks
I built a well drilling machine. It is hydraulic and all is great,,,,but? The cylinder for raising and lowering the mast does not operate right. Here are the issues :
1. Cylinder is double acting.
2. Valve is log splitter type.
3. Hoses are 1/2 inch.
4. Actuating valve causes engine stall and sever cylinder speed= very jerky mast action close to damage if not fixed.
Tried 1/16 orifice hole on one line but the same thing happened.
Your thoughts?
Thanks