dwyanehicks
New member
Notachance, are you still here? Thanks for this info. I replaced the rear sensor and got rid of my warning, but the front axle still breaks. Disconnected the rear sensor only, and the machine runs and turns fine. From your info, might this mean the front sensor is not working, despite there being no warning? Or could this mean the magnets in the rear need replacing? Can't think of anything else.
Your issue is probably related to the speed sensors in the axles. Test this by turning off axle matching (procedure in the operators manual) and test the machine. There is probably a sensor that is not picking up a signal and the one that is getting a signal is being cut back to match the no signal axle. Another way to test it is to unplug the speed sensors in the axles and run the machine.