ampa
Gold Member
- Joined
- Feb 9, 2009
- Messages
- 456
I'm usin' two double actin' cylinders/rams....one to raise and lowerin' my new plough the other one is for the left and right angle.....dumb question is this...... both cylinders/rams have a port/fitting nipple or whatever they are called :confused2:..... one at the top and one on the bottom...which input/fitting nipple under pressure drives the cylinder/ram up and which one lowers it.....I warned you all it was a dumb question....
I need and like to know this ahead of time...to save time...on changin' everything around if I connect them incorrectly.... hopefully I may get around to connect the whole system up either tomorrow or the next day...
normal operation for me would be when I push forward on the valve handle/lever.....I would assume it will raise up the snowblade and not down.....same with my angle.....
forward to turn it to the left and drawback on the valve handle/lever to bring it towards me which would be (my) righthand side.well this is the way I'd like it to be....someone left handed may want it completely opposite...I'm right handed......thanks in advance....Ampa :confused2:
I need and like to know this ahead of time...to save time...on changin' everything around if I connect them incorrectly.... hopefully I may get around to connect the whole system up either tomorrow or the next day...
normal operation for me would be when I push forward on the valve handle/lever.....I would assume it will raise up the snowblade and not down.....same with my angle.....
forward to turn it to the left and drawback on the valve handle/lever to bring it towards me which would be (my) righthand side.well this is the way I'd like it to be....someone left handed may want it completely opposite...I'm right handed......thanks in advance....Ampa :confused2:
Last edited: