Loader Pressure Release

[aeblank]

So in this thread (http://www.tractorbynet.com/forums/...face-hyd-coupling-pressure-3.html#post4108995) we were discussing how QD fittings can be hard/impossible to re-attach after some amount of time. Temperature changes, settling, etc. can cause pressure to be behind the fitting.

I created a manifold (got my parts from KennyD!) to equalize and, if needed, vent pressure when I go to reattach the picture. It's slow moving....I bought the parts months ago. I assembled it recently. I'll attach it in a month or two. I'll know if it worked about April. HOWEVER, here it is......

 

[bitternut]

I drop my three point down all the way and move my loader joy stick in all directions with the engine off. Been working for me for many years now.

 

[aeblank]

I do that too. I *always* get some sort of pressure in the loader by the time I need to put it back on. No point in quick disconnects if I have to use a wrench to remove them to get rid of whatever (STUPID) residual pressure there is. I don't know if it's the loader settling or temperature swings, or what. All I know is that it's a problem.

 

[aeblank]

Finally put the blower on, which means I took the loader off.

 

[J_J]

If you want to connect under pressure, then get the QD's that allow that.

If not, you have to make a dummy connector that relieves the pressure on the implement.

Sometimes the weight of the attachment will generate the pressure, and at other times the temp is a the problem.

 

[aeblank]

If you want to connect under pressure, then get the QD's that allow that.

Sometimes the weight of the attachment will generate the pressure, and at other times the temp is a the problem.

It's not that I *want* to. I try to get rid of all pressure (tractor off) and let the loader settle. I still have huge difficulties putting it back on, wrasslin' with the connectors every single friggin time. Temperature, I can't control, not to mention I don't want to be a slave to when I "can and can't" remove my loader.

If not, you have to make a dummy connector that relieves the pressure on the implement.

above is my dummy connector(s), with venting valve.

On my grapple, I connect the two sides together when I disconnect it. That keeps the connectors clean, and seems to eliminate any re-connection issues. I expect this manifold to perform the same function on my loader. I hope.

 

[Jabonee]

I like it!!! How much $ are you in to it?:thumbsup:

 

[aeblank]

I can't remember!
I also bought a spare set of QDs to have on hand for the loader (they aren't the "ag" type that the local farm store would have).
Seems like maybe $35. In tractor-money, almost nothing.

Woulda loved something like this, but they're only 3-up, and I needed 4.

 

[kennyd]

I can't remember!]

PM me your email address and I'll search for the transaction.

 

[kennyd]

It was about $40 spent with us (4 x $6.50, 3/8" Male 7241B QD's) and then about $10 for the fittings. The valve was not sourced through us.