North GA
Member
I bought a L3130DT with a LA723 skid steer QA FEL a couple of weeks ago. I ordered a pallet fork, tree boom, hay fork and grapple from Piranha and received them today. The Kubota QA pins must be a good bit smaller than the skid steer loader pins. I have at least a 1/4 to 1/2 inch gap between the pins and the bottom slots where the pins fit. In fact, the pallet fork has already detached at the bottom where the pins connect. Has anyone else had this problem and if so what did you do to correct the situation?
I can't understand why Kubota would promote a skid steer compatable hook up when a standard skid steer implement won't fit. The pins don't appear to fit properly on the FEL bucket. There is only about 3/4" of the tapered pin that extends beyond lower slotted hole.
Any suggestions will be appreciated.
I can't understand why Kubota would promote a skid steer compatable hook up when a standard skid steer implement won't fit. The pins don't appear to fit properly on the FEL bucket. There is only about 3/4" of the tapered pin that extends beyond lower slotted hole.
Any suggestions will be appreciated.