Willman
Gold Member
I changed my 4110 oil last weekend and installed the new Mahindra filter I got from my dealer a few months ago.
I filled up with Rotella 15-40 HD oil.
The tractor sat all week and this morning I went and started it to do some chores.
When I got off the tractor right after starting I seen oil gushing from the filter all over the barn floor.
By the time I got the tractor shut off (about 5 seconds) I was looking at a 3 ft. wide puddle of nice clean Rotella oil, about
1 1/2 gallons worth.
(I did run the tractor after changing oil & filter last weekend with no leaks whatsoever.)
After my initial shock I removed the oil filter to see what went wrong
Here's what I found.
The original filter installed from new had a flat 3/16" wide gasket with a overall width of 2 3/4".
The filter from my dealer had a larger o-ring style gasket with a 1/8" wide ring and overall width of 2 7/8".
I noticed the differance when I installed the new filter but figured it should work fine.
The filter mount has a machined step back on the flat sealing surface, just the right overall width for the flat gasket filter.
But with the larger o-ring gasketed filter, at one spot, the ring pushed past the machined step from compression and left a gap.
The filter my dealer gave me is the old part #14501673990
and the newer one is #14501673991.
But I now have a NAPA 1324 filter on and seems to work fine.
I filled up with Rotella 15-40 HD oil.
The tractor sat all week and this morning I went and started it to do some chores.
When I got off the tractor right after starting I seen oil gushing from the filter all over the barn floor.
By the time I got the tractor shut off (about 5 seconds) I was looking at a 3 ft. wide puddle of nice clean Rotella oil, about
1 1/2 gallons worth.
(I did run the tractor after changing oil & filter last weekend with no leaks whatsoever.)
After my initial shock I removed the oil filter to see what went wrong
Here's what I found.
The original filter installed from new had a flat 3/16" wide gasket with a overall width of 2 3/4".
The filter from my dealer had a larger o-ring style gasket with a 1/8" wide ring and overall width of 2 7/8".
I noticed the differance when I installed the new filter but figured it should work fine.
The filter mount has a machined step back on the flat sealing surface, just the right overall width for the flat gasket filter.
But with the larger o-ring gasketed filter, at one spot, the ring pushed past the machined step from compression and left a gap.
The filter my dealer gave me is the old part #14501673990
and the newer one is #14501673991.
But I now have a NAPA 1324 filter on and seems to work fine.