You nailed it. I finally noticed the switch acting bad. Replaced it. The old one had two terminals corroded. Probably would've been fine with a good cleaning but I already had a new one. Cleaned the terminals, added some dielectric grease and its all good now. :)
Tried to use the tractor this weekend and the batteries dead again! The only wire that looks like it could be chaffed is on the fuel pump. It isn't obvious, but those wires come out and turn 90 degrees back up under the pump bracket-- it looks bad and if I pull back the rubber grommet a bit I...
Turned out it was a blown fuse, but I checked the fuses AFTER checking the OPC Timer so I'm not convinced I didn't cause the fuse to blow by checking the wrong pin with the multimeter.. (that diagram is really not clear on what is pin 3 and 4) we'll see in time but for now its fixed and I...
Walked out the other day and heard the bx clicking.. constant clicking noise. Turned the key on and off and nothing changed. Turned the light switch on and it quit. Started and drove it a bit, then it would not shutoff until I turn the key off and the lights on.
I just put a new battery in a...
I'm looking for a 3PH Kit for my BX25. Dealer 1 wants ~$360. Dearler 2 and 3 want $218 + $40 shipping! and said it'll take 1 or 2 weeks to get it.
Is there an after market one I can get cheaper? if so where?
I see one on ebay but have no idea if it fits 3 Point Hitch Kit for Kubota Iseki and...
I know this is an apples to oranges comparison.
I'm 90% sure I'm getting the bx25; I know it'll fit my needs, but I can get a ck20 for about $2,225 less and am wondering if I should get it instead. (the bx25 is right at 15k with TLB, 3ph, and r4's)
Both have a loader and backhoe
Bx is almost...