Recent content by 310-510

Any leaks? 3 point speed knob (flow control) turned off. Any change in motor load when operating 3 point hitch? Rear remotes work?

To verify if it is tire interference, cut a swath in reverse.

Thanks MHarryE. I did not think of down assists. Every time the cables came off I would add slope to the tracks, adjust spring tension and limit the opening height. It only happened in the beginning when setting up the doors. 4 Liftmaster/Chamberlain 8500 on 12x14 sectional doors. I will...

5 years now without any trouble on my Liberty 41 gallon sewage pump. Easy install.

One

I blew plenty of O-rings. The hard line was replaced, the valve body was replaced, and after several 150 mile trips to the dealer, several self repairs, and many months of fighting leaks, I reached out to MIE. From MIE, For the return line from the Rear Hydraulic Valve to the Top of the...

Like Tractor Seabee, I raised the pressure to 2,000 almost 2,500 hard working hours ago. The factory spec for my BX24D is 1778-1849 and from the factory pressure was at the low end. All tires are foamed. The tractor has no trouble handling a full bucket even with the BXpanded bucket expander.

^^^^ Great answer and thank you.

My 3510SE HC has the same indication. Was trying to figure out if it was available, if it was an option, and how to use select it. So far it is not looking good as a useable feature. :-(

Stan B, thank you. I did see a picture of the PTO selection lever in the Owners Manual and thought maybe I could get lucky. :-)

It appears my CK3510SE HC has the indication of Economy PTO on the tach, a slot for the selector lever on the left by the seat, but no Economy PTO. Either that or I am missing something about Economy PTO. It might be nice to run the PTO generator in economy. Is it an option on the CK3510SE HC?

I had a second person just hold the shop vac to the fill port and very little fluid came out(read as just drops). Yes, the filter was removed from the shop vac as if using it for wet pickup.

Look into Pri-D. It will make it like new again.

I have 10 Senville units. DIY. 4 units are bracket / wall mounted with 6 ground mounted. Over 3 years and only 1 trouble. At the cost, I just changed out the unit. While removing the unit, the location of the freon leak was discovered. The unit is now my spare. The units work great when the...

I welded a 1" bar, drilled holes in the ends for the lynch pins, made 12"x12"x1" thick steel plates with a 1 1/16" hole and handle and it works for me.