Recent content by 491ton

Hi, I have a 3320 John Deere cab tractor, I am moving dirt with a 6' Danuser Hyd. scraper. I am filling my bucket, and scraper and traveling about 300 yards with rolling terrain. I have been disengaging the the front wheel assist when traveling is this a good idea? Also I'm running at 2500...

I think that there is air in my hydraulic system. Can an owner bleed this out himself at home? Thanks, Terry

I have a JD 3320 cab tractor with mid hydraulic outlets. I need a set in the rear. Is there a kit, Or an easy way to do it?

I just purchased off craigslist a Danuser HS-72 hydraulic scraper for $500 It has never been used, Just sat in a machine shed. Does any one out there have one of these? And is it as good as a box blade? Also will my JD 3320 handle it's weight when full of dirt? Thanks.

I have a 2015 3320 john deere utility tractor with hydro trans and 32hp. Today I was running my 5' new idea pull type mower thru tall fescue at 2200 rpm in mid range, going pretty slow, on hilly terrain, Then I noticed my pto was not turning, I shut off the pto and shut down the tractor. After a...

I have a John Deere 3320 with cab and R-1 tires fluid filled. My land is a bit hilly with black dirt over clay, In Iowa. Will it handle a 6' box blade?

I have a John Deere 3320 with cab and R-1 tires fluid filled. My land is a bit hilly with black dirt over clay, In Iowa. Will it handle a 6" box blade?

does anyone know how many gallons of ballast are needed to fill a 43x16x20 tire? I haven't found a fill chart with this size.

I have a 3320 JD I think it's 32hp. Will it pull a 7' box blade?

I have a 550# ballast box on my 3320. My pastures are pretty rough and the ballast box swings side to side on the three point. Is it hard on the three point to have the box on all the time?

I'm thinking of buying a magnetic block heater. Can someone tell me if the oil pan in my 2013 JD 3320 hydro. Is made out of aluminum or steel?

What different fluids can be used for ballast?

What different fluids can be used for ballast?

Hi, I have a question, Is there any way to lock out the float feature? on a 300x jd? Thanks.

Hi, I'm Terry. I am thinking of buying a used 5' box blade. The guy is asking $200.00 it is in very good cond. My question: Is this a good box Blade for my 3320? And is it a good price? Thank you.