Recent content by bozzchem

The ignition switch no longer works. I have to jump the starter to the battery to get the G1800 to start. THEN, there is the issue of fuel gauge and temperature gauges. They seem to work once the unit is started but sometimes they don't. I just want a G1800 that works! I've traced the wires...

I don't mind paying for a service manual but would prefer that it be in pdf format rather than old school paper format. I purchased what I thought was a pdf service manual for the G1800/S on eBay and found it was far from that and I let the person selling it know that honesty is a better policy...

I'm guessing my tiller has about 20 hours tops on it. Maybe I haven't stored it properly and maybe it's letting me know that. It starts on one pull....but the engine surges constantly unless I put it on full choke. Once I set it from choke to run, it's high/low/high/low etc. with the engine...

Well, I was going to take my daughter down to the garden so we could get some things done and my front left tire was flat as a pancake. I aired it up and it was flat again within 5 minutes. So, I made a soapy solution with water to determine where the leak was, aired the tire up and sprayed...

I was running the G1800-S last week and it overheated. I waited a bit for it to cool, it started right back up and I drove it back to the shed. I went out to use it again and it will not start. Once the glow plug is warmed and I engage the key to the start position, there is no noise...