Recent content by Brakeman

Hey guys, I picked up some stabilizer chains through MF dealer and was wondering about the mounting. The tractor has an Allied loader mounted which is mounted to the rear axel. The plate is about half inch thick and was wondering if it would throw the alignment off too much with the lower pivot...

Hey guys, looking to get parts for the lawn tractor. Right now it is just the bung for the fuel line at the top of the fuel tank but figure I will need others down the road. The model number is 944 606081. I have gotten parts through Sears before and the service was terrible and the ship was...

Hey guys, working on friends L 110 mower. We have put a new battery in it and i have gone through the connectors. All seems clean and in good shape. So i am wondering the best way to check the charging system. I have checked the grounds with the multi meter and they seem to be spot on.

Hey guys was just putting new boots on the Massey and I was wondering about any tips or tricks of replacing the toplink boot. I thought I read a post somewhere but I can't remember where. Thanks

Hey guys, just wondering if there is a way to find out what year a 384 was built. Found the serial plate and cleaned it off. And there was the serial number.. gone. Was the serial number just painted on and not stamped? Any help would be greatful. Found a number on the engine block, 3040912R4...

Hey guys I was just looking at haybines and was wondering if the 135 would run a 9 foot haybine? The little Massey has no issue on a 6 foot bushhog. It was going through pretty heavy hay and 6 foot tall burdock and thistles.

Hey guys, just starting to look for a larger tractor. looking for something like the 285. I was raised around IH so I was thinking of something along the 656, maybe a 786. Main things I'm thinking is can the 285 pull a 5 furrow plow as well and does the multi power stand up better than the...

Hey guys! Just picked up a used drawbar from the wreckers and it was bolted on ( he didn't supply the bolts). But I would like to keep the studs. Just trying to find the proper nut size they look like fine thread. The wrecker thought that it was strange they had studs. Its for a massey 135uk

Hey guys! I was looking through the post and I couldn't find any on the 135 plowing. I was wondering what the 135 would be able to plow in average ground (not to much clay) 2 or 3 furrows and size of furrow. The rear tires are loaded. So any do's or don'ts would help

Hey guys its starting to get cold and I'm looking for a way to preheat the Perkins diesel ad3 152. Just wondering if there is a block heater out there for it. Talked to the loco (local) dealer with no help. I don't want to use ether. Not big on Knock Knock jokes any ways, any help would help...

Hey guys I'm adding some lights to the tractor and was wondering about replacing the generator with an alternator. If there is much work and cost. Also if anyone could tell me if there is a blockheater that fits the 3cyl Perkins diesel. I'll need something to help it start this winter other...

I guess I should have mentioned that I'm a Canadian, eh! I thought there wouldn't be a difference between Canadian and American tractors. I took a couple of pictures of the front axle to see if that helps Farmwithjunk about figuring out the model or year of it. Thanks for the breakdown of the...

Thanks for the quick replys. I took a few picture of it and I hope they will do some good.

I just picked up a Massey Ferguson 135, I beleive it was a good deal, it runs good the hydralics work and it came with attachments. And heres the but it does not have a pto. Just wondering if you can do a field conversion and how difficult it could be if possible. I got the numbers off of the...