My 2007 2305 with 160 hours has started eating coolant. It runs great, no drips at all, no odors, no smoke. In cars when this occured it was bad head gasket, but then you would see white smoke or bubbles in the radiator. Ideas?
Dropped a 30lb rock from bucket onto hood, bad dent. Is hood plastic, metal, fiberglass? It dented hard, must be metal? Searched internet, cant find a hood anywhere! Where are they, what cost?
At 111 hours a few weeks ago the engine will start to die from 2800 to 2000 rpms, then climbs up again. Now it runs and shuts down. Checked forum and tank cap vent is OK. Now I see that my clear fuel filter housing shows the fuel is being used till empty leading to shut down. You can then see...
My 2305 with the 54" deck and power blower never really worked well. When you cross just a few leaves they usually blow out from under the deck. It seems to pick up grass OK as no grass clippings are left and the 3 bags get full.
I thought that putting high lift blades would help but they did...
At 95 hours I pulled my oil and filter. Oil was pretty clean considering it's original oil. The oil filter I needed to borrow a smallllllllllll filter wrench, and then had to stand on it to get it off. Factory must have used locktite on the gasket.
Hydraulic oil looks new and was at correct...
I used to be able to lift my tractors' front end with my snow blower. Without using the 2 ski's. the scraper edge would get down tight and really clean.
Now this year for some reason, the blower just rests on the driveway, it either needs Viagra or something is wrong...what did I do, or forget...
Hard to explain here. When i raise my mower deck, sometimes the thick black L shaped piece of steel slips past the black arm that it attempts to raise. I know i am explaining very poorly. The following has you behind the tractor, looking at the rear of the tractor.
I have the shaft spacer...
My 2305 with a 54" deck has the John Deere 3 bag collection system. This is junk, JD should be ashamed to put their name on it. Yes, it is working properly, nothing clogged, pto rpms are correct, I was going slow. My old 425 pulling a Curtis cart was much better. I had it today when picking up...
My mower deck at the highest setting still cuts grass too low. Is there an adjustment somewhere. From the decks highest position, when I drop deck it lowers about 1" or so...but the grass is cut too short. What length of grass do you think should be left with the deck adjustment set at H........
My 2007 2305 has an idiot light for engine temp...what bs. I want to see tempertures so I get to know what is normal, and to see when temps start to get high. I don't want to know when I have a probelm, I want to be proactive. How can i install a temp gauge, and where?
How do I clean grass clippings that are jammed between the metal screen and the plastic lid of the grass collector? Hosing only jams them in the corners, and you can't remove the metal screen, it is pop riveted.