Recent content by FritzII

I'm thinking about purchasing a diesel zero turn. Is it possible to get a rear discharge mower on a ZD323 ?

The seat is starting to fall apart on the Kubota. I think a new Kubota seat is around $140.00. Has anyone replaced theirs with an aftermarket seat that they like ?

I have a problem with this tractor not starting. It will click when you turn the key and do nothing. (Like a dead battery) I took it to the dealer and they cleaned all the terminals on the tractor that would cause it not to start. Other than that, they told me that they could not find anything...

I have a work light on the back ( that came from the factory ) with an integral on/off switch. I was wondering if anyone knew of any led work lights with integral switches. I'm thinking about mounting 4 lights on the ROP and I'd like to have them with built in switches.

I just picked up the powered rake for a decent price. Some of the tines are broken off and I was wondering if I should replace them or just forget about them ? They look king of useless to me. What would the tines be good for ?

I'm thinking about changing one of the rear remotes to a detent type ( to run a log splitter for example ) This would be on an R3039H. I know I can strap the handle open, but I would rather have the detent kit if the cost is not through the roof. I think LS offers this as a kit ? Does anyone...

I've started the search for a BH. Can anyone tell me if there is a subframe model available for the LS ( McCormick ) tractor ? I sent an email to Spirit to see if they still offer the MH76, but have not heard anything yet. I will call if I don't get a response. I do like the look of the Woods...

Can anyone tell me the paint code for the red on the CT series ? TIA !!!!

I'm a little late posting this, but I wanted to pass it along. I keep my tractor in a lean-to and run off road fuel ( no additives ). I wasn't too sure the tractor would start @ -12 F, but I figured I'd give it a whirl so I could remove about 5 inches of snow. It took three tries. First two...

I have a buddy that is going to sell his 3 point hitch BH. He only used it once and I can get it for a good price. Can someone tell me what the CT36HST would require to add the BH to it ? TIA !!!

I'm a little bummed at the jerky 3 point hitch when raising it in little increments. Anyone else have this problem ? There is no jerking when raising to the full up position. It happens when I try to lift the box blade a 1/4 inch or so.

Are you McCormick guys using McCormick fluids and filters ? If not what would you recommend ?

In my opinion, the manual that comes with the tractors could be written a little better. I like the tractor though !!! I believe that the check point for the hydro fluid, for the whole system, is on the rear axle housing in the lower right side ? ( If you are standing behind looking forward )...

I posted this in the McCormick forum also. I am trying to figure out what switch will fit in the face of the loader control handle. There is a flat plastic plate/insert that looks like it can be replaced with a switch ? It would be operated by your finger tips. Does anyone have something like...

I am thinking of putting an electric diverter and additional hydraulic lines on the loader for grapples and such. I notice that there is a plastic plate, on the face of the loader control handle, that looks like it can be replaced by installing a switch. Can anyone tell me what will fit in there ?