Recent content by JYD

Thanks for advice. It’s well appreciated My bigger concern is tractor is way out in woods. So a arm and leg to get out Stay tone

Have service come out. Looks like cam shaft that spins were fuel sensor goes is frozen They r going to have to take in I afraid on how much it will cost

I replaced this part. Cranks over but does not start Any suggestions

Got new part

Thanks I’ll look at in am

Branch hit middle hose

It cranks. Turns and turns. Did turn off pto

I need help Was brush hogging and a large branch hit one of the hydraulic lines shouting off tractor. I removed the branch but now will not start. A tiny. Bit of fuild escaped Turns over but no start. I’m in the middle of no were Any suggestions??? I will go to dealer tomorrow Help

Hi All looking for some help. I lost my key and do not have a spare. I am soo mad, that I did not make a spare. what is my best option.. parts seem hard to find, but can I just replace the ignition? or can a locksmith, make me a new key or can I put in a aftermarket ignition? any...

HI All, I need help with the following. Would like to get you opinions before taking to dealer... I have JD 4230 with load (hy-guard) R4's rear tires. 100 hours Noticed tires where a low, so with value on top added air. The first thing I noticed is when I took the valve cap off air...

HI All I have a JD 4530 and noticed my rear tire is low on air. It does not appear to have a leak. You really notice it when I have the cutting deck on. The tire is filled. Not sure what the tire pressure is but will check. My questions is I want to add some air, is there anything special...

HI All, I recently purchased a kk 72 tiller, and it is my understanding that I need 6 inches of overlap on the pto shaft , I am 2 inches short so I purchased a pto adapter and now I am at 6 inches. My question is , does it matter what end of the pto shaft I put the adapter on ?? Also, the...

HI All, I recently purchased a 72inch king kutter tiller. I have jd 4320 with imatch. I have read a few post where people have altered the implement to fit the I match. How is this done? Has anyone done it with a kk tiller? any photos? I also purchased pats ez change because I knew...