I paid $680 for my steel blower.
Today I have gutted the entire blower assembly, some lazy knothead left a cord in a parking lot in the snow, which of course would around the auger gearbox and took out the seal. Not a nice job to replace by any means.
I sold a very nice little Massey gc2400 that would throw snow 80'. This bigger more powerful JD throws it about 10'. I tried loading the blower heavy with a good row from the rear blade first, going faster, slower, nothing makes much of a difference. There is about 4-6" of fresh snow, not real...
I had a wonderful little Massey GC2400 with a snowblower and cab, used it all winter and just loved it.
Trouble is I also have a very low hour 2014 JD 2032r, with front end loader, 655 tiller, 65" MM mower, wood chipper and weight box.
The massey is really a single use unit.
I tried for a few...
I just started my loader, and flashing on the screen is can bus timeout- press return. Pressing any of the 4 buttons does nothing. Any ideas?
Everything seems to be working fine except for the air ride seat compressor will not run.
In today's episode of 'what did you fix on your Massey GC2400 today'......
The rear facing heater vent always falls in. I even switched it with another location, same problem.
Today I beat it into submission.
2 tiny holes drilled and 2 tiny screw/washers installed, all you have to do is...
My 2012 only has 70 hours, but the motor seems to be failing. Sometimes it does nothing, no noise. Sometimes the motor spins but not the chute, turn it by hand and its not frozen or locked. The shaft locks are tight, no play anywhere.
Has anyone found a replacement bolt in motor? Love the unit...