Recent content by lost in wisconsin

Our toolbox (generic Fleet Farm toolbox mounted to the rear behind the seat): Our chain storage (ammo can mounted to the frame under the grille guard):

Sure... The item circled in red is the attachment for the throttle lever. This is removed by pushing back the rubber boot from the dash, sliding the boot up the throttle in order to give you access to bolt securing the lever. I believe it is a metric bolt. Once removed the throttle lever comes...

Once the PTO SHAFT and the IMPLEMENT DRIVE AND UPSTOP are together, attach the IMPLEMENT DRIVE AND UPSTOP to the Front Attaching Support Kit. Once they are attached, then connect the PTO SHAFT to the MIDMOUNT PTO.

If you do, I would then recommend placing the PTO SHAFT inside the IMPLEMENT DRIVE AND UPSTOP.

Lets start with the FRONT ATTACHING SUPPORT KIT... do you have either one of these attached to the frame of your tractor?

Good morning, This is what we did for our 2520. I wanted something that mounted behind the seat yet did not create an interference with the seat or the 3 pt arm. My preference would have been plastic but I found this generic metal toolbox at our local Fleet Farm. I did paint the box as the...

Good morning, 2-3 years ago we "reworked" some ground to make some more pasture for my wife's horses. It was basically overrun with weeds and thickets. One fall was spent pulling out the thickets and roots. The following year, we had a number of other projects occupying our spring and early...

In response to Deere 2520's post last week regarding installation of a rocker switch for an electric actuator, I thought I would finally post how I handled this task. I completed this task in January of this year. This is by no means an original idea of my own but instead my plan after reviewing...

About 2 weeks ago, we took delivery on our 2011 2520. Like many others here, we took advantage of the $2500 promotion and signed the papers on May 31. The 2520 was on the lot and if it had not been there when I stopped a week prior, I doubt we would have considered purchasing a different tractor...

Wasn't sure where I should post this thread but since I had a few pics, figured "Photos" was as good as any. This was our recent experience with an unwelcomed hitchhiker... My wife and I work for the same company and sometimes commute with each other when our schedules allow. On this...

We are to take delivery of our new 2520 in the next week or 2 (waiting on arrival of FEL). Unlike many others, the dealer I stopped by had one on the lot. Whereas I have no reason to doubt the information the dealer provided me, is there a way I can determine the date of manufacture by looking...

Later today I intend on removing my front mounted snowblower from our JD 2320 and putting the loader back on. Because of our lack of space for inside storage, I had to leave the loader outside this year through the winter. Is there anything special I should keep in mind or do before either...

Larry, Very nice write up. Quick question (just because I am always curious), but what is the 'linkage' or attachment circled in yellow? Is that for another attachment? Thanks

Here are a few pics of the Heavy Hitch my CFO had delivered as a late Christmas gift:

I was at the dealer earlier this week picking up some supplies when I happened so see a 47" snowblower sitting next to the new ones still in the crate. When I inquired, the salesman informed me someone had upgraded to the 54". Dealer is asking $2400 for the entire setup including hydraulic...