daRedbone
Member
I have a '05 model 5105 with just under 600 hours on it. I was using it to clear under brush with the box scraper when the problem began. I was working it at an idle. It revved up slightly while I was looking backwards. I thought I had bumped the foot throttle. About a minute later it did so again returning to idle immediately. Then it began to do so with regularity while feeling like it was down on power. I ran it wide open as I went to the shed. It sounded bad but moved with ease.
Once I made it to the shed I idled it down and dismounted to see if I could see anything wrong. It idled for less than a minute and died. It would not start again.
I changed the fuel filter and drained the water separator. There was no water in it. After priming the system it still would not start. After following the directions in the manual on how to get air out of the system it still will not start. I disconnect the 3 lines from the fuel pump to the injectors at the fuel pump. I turn the motor over and zero drops of fuel come out. I start the tractor on starter fluid and zero drops of fuel comes out.
I check the voltage at the solenoid. 11.5 volts with the key on and an audible click in solenoid when I turn the key on. There are 2 other wires attached to the solenoid but I have no idea what they do.
I'm stumped. Please help.
Once I made it to the shed I idled it down and dismounted to see if I could see anything wrong. It idled for less than a minute and died. It would not start again.
I changed the fuel filter and drained the water separator. There was no water in it. After priming the system it still would not start. After following the directions in the manual on how to get air out of the system it still will not start. I disconnect the 3 lines from the fuel pump to the injectors at the fuel pump. I turn the motor over and zero drops of fuel come out. I start the tractor on starter fluid and zero drops of fuel comes out.
I check the voltage at the solenoid. 11.5 volts with the key on and an audible click in solenoid when I turn the key on. There are 2 other wires attached to the solenoid but I have no idea what they do.
I'm stumped. Please help.