Search results

I took the radiator, Part# K7711-85210, off and took it to a radiator shop and they couldn't fix it, pulled the tubes out of the bottom rail and bent the frame etc. I found a replacement at apairinc.com. It cost significantly less than other options. There were others that I probably could...

I put a stick through my radiator. I'm going to take it off and take it to a radiator shop to see if it can be repaired. Looking for options on replacing it w/o breaking the bank. Has anyone else replaced w a different radiator w good results? If anyone has the dimensions, I'd appreciate...

Does anyone have a clear picture or diagram of how these things are supposed to be installed? :confused: They're for a 73 Ford 4000. Here's what my lift arms look like, they could have something missing where these are to attach, but I couldn't find good example of how they go on.

I'm looking to replace my generator with an alternator. The tach runs off the tach drive mounted on the back of the generator. I have been looking and found some on ebay, but don't know if they will fit. New 1 Wire Alternator Massey 7 8 18 18 11 115 165 175 with Tach Hookup | eBay and...

I have a small pond, 1/4 acre. I recently limed it and have been fertilizing it. There were some fish in it and I added some this spring. A few bass, bluegill, some channel catfish, and some minnows. I have a bunch if these fish an wanted to know if anyone knew way these are. I think...

Hello all, longtime since my last post... Was wondering if anyone has any sage advice on tanning a couple of coon skins? Including any gotchas to look out for. After skinning them I put the pelts in the freezer. I shot two with a gun my dad left me, 22 Stevens. Shot them with open sights...

I was mowing the yard yesterday on the old ('77) wheel horse and while navigating close to a fence, I bumped into a hosebibb that comes straight out of the ground in 1/2" galv pipe. Mowing turned into a plumbing project. Our place is about thirty miles from any hardware store that is open on...

'66 MF135 ready to pull the sleigh! Hope y'all have a merry Christmas!

Have found a few of these in the shed that the previous owner had in there, along with a bunch of other stuff. Can y'all identify this thing?

I have a few trails (for tractor) on our place in southern Ms, north of Poplarville where rain, over time, has washed the sandy topsoil away leaving hard clay with deep ruts here and there. How can I fix these and prevent them from occurring? Short of putting in a real road. Thanks.

I have an old sucker rod type of water well at the farm. It has about a two inch casing with an old Fairbanks-Morse pump sitting on it. It has about a six inch throw that attaches to the sucker rod. The well is about 30-40 feet deep. The rod has fallen down in the well. Does anyone have a...

Hello all, first post... 1966 MF 135, when I raise the implement, it shakes / shudders. It goes up w/o any problem other than the shakes. Goes down smoothly. Any idea what the cause / remedy could be? Also, I noticed that if I leave it up with a load, say the bush hog, it will, very very...