Search results

Results 1 to 8 of 8
  1. K

    Oil & Fuel  Massey Ferguson 203 Industrial Tractor Manifold Preheater

    Does anyone know if the above tractor has a manifold preheater and if so how is it activated? I recently acquired the Massey Ferguson 203 Industrial with loader and backhoe and have been having to use starting fluid to start it even at 40 deg F.
  2. K

    Leaky Kubota B2400 Front Axle

    Has anyone else had a leaky front axle on a B2400? This was a new design of theirs in 1998 that uses o rings on the front axle pivot point to seal the fluid inside. It always leaks at the pivot despite having been repaired twice already (new o rings twice, pinion seal and new housing last...
  3. K

    Diesel Engine Oil

    My Kubota recommends 10W30 engine oil for diesel. I've always been able to buy it at my Kubota dealer. Anywhere else I look seems to only have 15W40 diesel rated oil. Does anyone know if Valvoline makes a 10W30 engine oil for diesels?
  4. K

    Sharpen Brush Hog

    I have an old Howse 4 foot Brush Hog and have always sharpened the blades with a 4" grinder with the Hog raised on the tractor and blocked up. The downside is that a 4" grinder really only gets the ends of that hardened steel and never truly grinds down the entire taper of the blade like it...
  5. K

    Land Pride FDR1660 Finish Mower Belt

    I have a two year old Land Pride FDR1660 finish mower. The first belt lasted two years and only went bad because I let it get too loose. Since then replacement belts have only lasted a month or two. The Land Pride dealer wants $62+ for his belt with a GENUINE Land Pride part number...
  6. K

    Kubota L3350

    I recently acquired a Kubota L3350 glide shift 4wd. It's really well used but it was relatively cheap. All the electrical gauges aren't working as well as headlights but I do have voltage at the fuse block. Occasionally its hard to get started, nothing comes to life. Giggling interlock...
  7. K

    Oil & Fuel  kubota B2400 Starter Fix & Fuel Problem

    I have a Kubota B2400 plagued by a clicking only solenoid. Checking voltage under load at the solenoid yeilded only 6 volts (barely enough but not to really engage it). I went to Auto Zone and got a 3.99 relay putting 12 VDC full thru the relay contact. I drive the relay coil off the wire...
  8. K

    kubota B2400 Starter Fix & Fuel Problem

    owning-ML-859883-ML- Kubota specific thread. Does anyone read the forum descriptions anymore? :)
Top