Search results

Anyone out there have an 1100c with a factory rear window screen? If so can you still use the 1" square holes (i.e stake holes) in the corners of the bed? Looks like a very close clearance

Does anyone know what the hydraulic capacity (ie volume of reservoir) for the dump circuit on above RTV? This would be different than than total capacity of hydraulic fluid listed in the manual as there are two reservoirs. One for the engine and one for the dump piston. While I'm at it, anyone...

I'm considering purchasing the above RTV. I would like to attach a hydraulic dump cart which has a 24" piston. One dealer says no problem. It will need a step-up fitting to mate with the difference in hose size. They say it will take longer to dump due to the RTV's smaller hydraulic pump than my...

I snapped a Zerk fitting on one of my loader pins and can not back out the remaining threads (using a remover from a tap set). Never had that problem before. Is there any trick to replacing the entire pin or is it as easy as it looks. I assume the pins are relatively inexpensive? This is a...

Have a B21 that I've had in a good (high traffic) location in Central NH for about 6 weeks. Lots of tire kickers but no offers. I've just reduced it to $20.5 K from $ 21.5 K. Is this a reasonable price to you guys? 95hrs, loaded tires, new condition, 2005, still under warranty! New around...

If I am careful to keep it clean, can I recycle my hydraulic fluid during the change of filters? ~10 gallons. Kubota L39.

Just got one from Harbor Freight. Seems to be made well enough, albeit a little rough in finish. Are you supposed to use both bolts to attach the top hook? When I use both , I can not get the pin on my Land Pride blade to travel to the bottom of the quick hitches' hook. This is due to the...

I have a small rake that requires 3/4" pins for the lower links. The standard 7/8" ones are too large. Does anyone know of a place to buy these pins? I'd rather get the pins for $5 than spend $20 for a 1" drill bit that I'll likely never use again.

Anyone put chains on a L 39. Are wheel spacers required?

Anyone ever tried studded tractor tires? Or, placing (hex head) screws in the tread?

When your loader is set to float, is the entire weight of the loader on the implement? I am considering using a 5' wheel-less rake on the loader and wonder if the load will be too much weight? Using it to rake small debris in/around some trees. TL 1000 loader on a Kubota L39.

I have a L39 that has a seat safety switch that is so sensitive that if I lean to one side the engine "cuts out". This happens even if I am leaning slightly to one side trying to get a better view of the front implement. Is there any way of decreasing the senisitivity? If not how do I disable...

Has ayone had any experience purchasing/using Unlimited Fabrications' Root Grapple or any other of their atachments? Quality, service etc.

Has any one used / seen Unlimited Fabrications products? Especially their root grapple.

Have an opportunity to buy a L39 with 107 hrs. with the following additions Hydraulic thumb hydraulics to front 2 extra hydraulics to rear 4 in 1 bucket Kubota Pallet forks Land pride scarrifier 66" Land Pride rear blade 7' Land pride SH-35 Quick attach (skid steer mount to attach 3 pt...

I'm looking at an L 35 w/ 1300 hours located at Riverside Tractor (formerly Walt's) in Berlin Vt. Has any one had any experience with them? Good or bad.