Search results

I have a GC 2300 with the Iseki 2.9L. It sometimes will run for hours and then start dying. If I back off the throttle to idle it will not die, it will resume idle and I can throttle back up. Sometimes it just will die just sitting there idling. When it dies it starts by losing RPM's gradually...

I cannot get my 5310 to start back up. It started losing Rpm's and died. Have good fuel, replaced fuel filter, primer, air filter. It started and ran for about 2 min. but would rev just idled, then died again. Now it will not start at all. Have bled fuel system to injectors, still no start...

I tried to use the frontend loader to pick up the front end to change a flat tire in the field. When I got the tires off the ground, I let the loader handle return back to normal postion and the loader just let the front end fall back to the ground would not hold its position. I do not notice...

I tried to use the frontend loader to pick up the front end to change a flat tire in the field. When I got the tires off the ground, I let the loader handle return back to normal postion and the loader just let the front end fall back to the ground would not hold its position. I do not notice...

I am getting ready to change the fluid in the hydro/trans and filter. I have read on here about cleaning the screen when you do this. Could someone please tell where the screen is so I can make sure and clean it. Filter is on bottom right and PTO on bottom left. I just do not see the screen...