Search results

Has anyone built a frame for reel mowers. Thanks for any help. Paul Dyar

I am having trouble finding seals for a post hole digger. The make is unknown. The input shaft is 1.25 the od of the seal is 1.75 The output shaft is 2.0 the od of the seal is 2.6250. I have called 2 places and been on Timken site. So far no luck. The number on the cap is 901212250222. Thanks...

My tractor (TC33DA) is leaking coolant out of what appears to be a drain plug right above the oil filter. It is leaking where the thing screws into the block. I am hopping that all I have to do is take it out and put something on the threads. Has anyone had this problem? Thanks, Paul

I have a TC33DA it has a ring bolted to the transmission case, I am assuming that it is a tie down point. If it is, how much tension can be applied to it? Paul

Is there a reason no one puts shocks on trailers? Paul

I am having trouble finding large hinges for barn doors I am planning to make some. Is it worth the effort to make them? The doors will be 6' wide 8' high. Planning to make the frame out of 2x6. Not sure about the sheathing yet. Paul

I had hauled sofa and loveseat to Stone Mountain. On the way back (approximately. 10 miles) I noticed the left tire was locking down when I braked. The most it could have slid at any one time would have been approximately. 15 feet. I know the brake controller was set to high, but I have slid...

I've noticed a knocking noise in the transmission area when in idle. If I depress the clutch it stops, that makes sense. But it also goes away when I increase the RPM. Everything is working fine, hydraulic level is ok. May have been doing it before and not noticed it. Is this a sign of a major...

Would there be a problem mixing different ply tires on a trailer. The tires will be the same size. Thanks,Paul

I purchased a used trailer that has Bluestar tires, 700-15 LT. One of the tires was damaged. They had put a mismatch on it. I have been unable to find Bluestar on the net, and the dealer I usually buy from hasn't heard of them. He is going to check Monday to see if he can get one. Has anyone had...

Any way of telling the weight capacity of axels. I have a converted boat trailer with tandem axels and would like to know what capacity they are. Thanks, Paul

It is my understanding that you have to run a 4 wire cable now. Is the old 3 wire not safe? Is the power co. going to change all the old power feeds? Paul