Search results

I started up my jinma 354 today to warm it up, I was doing some nearby work when the rpms started dropping slowly, Then it stallled. When I tried to start it again the starter would only clunk and not turn it over. I noticed that some oil had blown out the drain plug and sprayed on the ground...

Ive got a 354 that only starts with a jump. the lights are bright when it runs but if I stop it I have to jump start again. the amp meter doesnt work as well.Great power, pulled my plow truck out of a culvert when it was hung up so bad the right rear wheel wasnt on the ground. Any ideas or is it...

who knows of the best price on a woods back hoe, 750 or 900

on the jinma fel there is an adjustment for the valve on the bottom of the operating block where all the lines go in. is there any limit to how far you can adjust that. obviously You stop turning it when it bottoms out but will this over presureize the system?

so if you got larger cylinders for your F.EL. would you affect the tractor in a bad way?

I had a post about foaming hydraulic fluids and i checked my hyd. oil after a few days and the foam comes from water. turns out we had a rain storm while I was at work, not alot but enough(had the tank lid off to clean it out). how in the heck can i get it all out. drained the tank of course...

I get alot of foam in my hydraulics. this I associate with air getting in the system. I think my back hoe is what's doing this.how could I find out for sure without using 2 more gal of fluid?

does anyone know if an home heating oil co will fill a 55 gal drum for fuel

I have a Jinma with a bad pump. it had metal shavings in it. it was'nt factory debured. so I cleaned it up debured it got it to spin easily but it dos'nt pump any oil. I cleaned the filter,flushed the tank made sure all the lines are clear and connected. The drive spline is good and the...

has anyone added a hydraulic filter to a jinma? Thinking of adding one to keep the hydraulics clean and responsive.

I have a Jinma 354 and Im looking for Fram Nappa or other filter. The number on the the Jinma filter is jx85100A Any help would be great.

are there any pto driven salter sanders that can handle the job? I know there are 12v dc units to spread salt only, are they any good?

Iwondered if anyone has built a screener or knows of plans to make one. I live in a rock infested area and would like to clean up my side of driveway from the clay/rock piles, make a drainage ditch and fill it with rocks from my property. Any ideas?

ok I'm gettting a new jinma and never had a diesel engine before. is anything like stabil needed do they get varnish like gas motors? any mix I get now does it need anything to prevent gelling. can alcohol be used to keep water out.

I'm in massachusetts and have been looking for a grey/iseki dealer. anyone know of one? anybody buy a rebuilt grey off of ebay?

I am new to tractor buying and I was wondering how good Jinma is; are they strong and reliable or prone to any problems? also what size 4wd unit is good for a loader back hoe to fix up a gravel drive way and dig up small stumps and brush?

I saw an Iseki tractor for sale on ebay it was a 30hp 4wd rebuilt unit. only problem is it was in Texas and I'm in Massachusetts; the shipping would be alot. Any one know of a more local Iseki dealer? Also any one buy one of the tractors rebuilt in Japan?

I am lookong for a Iseki dealer in the N.E. I really would like one in M.A. Or is there a good deal on a 30 hp. 4wd. loader? what about shipping? Thanks for any replies.