1652 won't start

   / 1652 won't start #1  

tractorski

Silver Member
Joined
Sep 15, 2005
Messages
117
Location
southern Vermont
Tractor
Branson 3510
I was working with the tractor, i put the front end in the garage to take the loader off. I got the loader unhooked and shut the tractor off to un hook the hydraulic lines. went to start it back up and it won't start. Motor turns over fine and I can hear the fuel pump working, but it won't fire. anyone have any ideas? it has plenty of fuel. I checked, cleaned any electrical plugs and checked the fuses.
 
   / 1652 won't start #2  
It's likely your seat safety switch. Bounce on your seat a couple times and try starting again. If that fails, unplug the connector on the bottom of your seat and put a jumper wire across the terminals of the wires leading to the tractor to test if the safety switch is malfunctioning. Good luck. Steve
 
   / 1652 won't start
  • Thread Starter
#3  
Well, it was the injector solenoid, I had to wait for it to fail completely before the dealer could find the problem. Done.

Sent from my iPad using TractorByNet
 
   / 1652 won't start
  • Thread Starter
#5  
Yes, the tractor is 2 years and 11 months old, I just made it by a month. I am sure the cost of the flatbed ride is not covered though.

Sent from my iPad using TractorByNet
 
 
Top