MarkAnthony
New member
- Joined
- Apr 20, 2004
- Messages
- 4
for a 3pt hoe that runs on the tractor hydraulics, wondering how to plumb it. The engine pump goes to a koyker 160 (not sure if there is a free outlet on the spool, looks like there is), then it goes to a diverter or flow check which feeds the power steering and 3 point. The hoe guy says to disconnect the quick connect between the pump and the loader and run a loop to the back. The question is, there is a return quick connect already on the tractor in the rear from the factory. if I use this for the return for the hoe then where do I get pressure from if I do not break the loop as suggested? it looks like that diverter/flow valve has an extra port on it. if the factory supplies a return then did they provide a port for pressure side? Suggestions? Thanks, Mark.