cnsJohn
Bronze Member
hello Everyone,
I've seen this topic discussed, but frankly the discussion has left me more confused. The Toe on my front wheels (Jinma 354) is off badly. I can turn one wheel 25 percent to the left and the other is still pointing right. The instruction I've seen says to loosen the lock nuts on the tie rods and turn the traversal bar/rod. The bar I have is bent to go around the frame. When turned, it strikes the under side of the engine above it, or the frame below. is the bar supposed to be bend around the frame? If so, do I need to remove the ball joint so I can turn the tie rod? And if this is the case, how do I remove the ball joint? I tried removing the cotter and nut from the top, but the ball joint did not fall from the wheel mount.
I apologize for my lack of knowledge on the subject. Your advice and experience is greatly appreciated.
JohnJ
I've seen this topic discussed, but frankly the discussion has left me more confused. The Toe on my front wheels (Jinma 354) is off badly. I can turn one wheel 25 percent to the left and the other is still pointing right. The instruction I've seen says to loosen the lock nuts on the tie rods and turn the traversal bar/rod. The bar I have is bent to go around the frame. When turned, it strikes the under side of the engine above it, or the frame below. is the bar supposed to be bend around the frame? If so, do I need to remove the ball joint so I can turn the tie rod? And if this is the case, how do I remove the ball joint? I tried removing the cotter and nut from the top, but the ball joint did not fall from the wheel mount.
I apologize for my lack of knowledge on the subject. Your advice and experience is greatly appreciated.
JohnJ