FergFan
Member
Replacing my 12v Ignition coil on my Ferguson TO30 Z129...I've just installed my 2nd 12v ignition coil and I'm still not getting a spark out of distributor side of the plug wire. I've tested the ground on the coil and I've got nearly 12 volts(11. sumt'n) going into the coil..Whats the proper way to see if I'm getting spark out of this coil, other than holding the end of the coil plug wire up to a bare area of metal on the tractor.....plug wire is a bit short, only been able to hold plug wire from coil up to a bare spot of metal on the starter or up to the bolt on the side of the starter.
Should I be able to see a spark out of the coil ignition plug wire on the distributor side by doing this?
Should I be able to see a spark out of the coil ignition plug wire on the distributor side by doing this?