NHmitch
Platinum Member
I just needed a bit of advice if anyone knows about the 4wd front gear case. case. There is one on each side, and there is a grease zerk on the top. I believe the grease goes into the socket that hold the front arm that looks like a silver bowling ball, I think its called the king pin. Sorry, I don't know the correct terms. The question I have, is I was greasing all of my fittings, and on both the right and left side on top of the gear case, I put a ton of grease in both sides. Is that normal for that grease fitting to hold that much grease? I think that it lubricates the front ball joint looking thing, but I just wanted to make sure. I put about 14oz of grease between the two, and I. If anyone knows if that is normal, that would be greatly appreciated.
Mitch
Its the silver ball looking part on the inside of the front tire in this picture that you can see behind the right front tire. The grease fitting is on top of this part of the gear case and is called the king pin.
Mitch
Its the silver ball looking part on the inside of the front tire in this picture that you can see behind the right front tire. The grease fitting is on top of this part of the gear case and is called the king pin.
Last edited: