LD1
Epic Contributor
A landplane dragging a piece of fence sounds like what you are envisioning
Brainstorm with me!!
- Thread starter HawkinsHollow
- Start date
OP
HawkinsHollow
Veteran Member
Almost. A FREE homemade landplane dragging a piece of fence is exactly what I am imagining.
Bansil
Gold Member
- Joined
- Mar 14, 2016
- Messages
- 309
- Location
- State Of Franklin
- Tractor
- 1967 Ford 5000 w/FEL(sold), 1950 Farmall Super A for the wife to drive around (needs fixed) 2024 Kubota B2601 FEL & BH
Grab a 4x4x1/4" PC of steel angle, draw 2in teeth on one side, use angle grinder to cut out teeth, clamp to bucket lip with teeth facing down and drill 5 holes in the uncut side to bolt to bucket and now you have teeth you can back drag with...
Look at the similar teeth on the Rake I'm building, bottom of this page
Rake teeth
I can take a picture of 1 I started on for my old tractor in a couple hours, very simple and minimal tools
Look at the similar teeth on the Rake I'm building, bottom of this page
Rake teeth
I can take a picture of 1 I started on for my old tractor in a couple hours, very simple and minimal tools
Jrasband
Gold Member
- Joined
- Dec 31, 2021
- Messages
- 382
- Location
- Southwest VA
- Tractor
- 2022 Kubota M7060, 2014 LS XR3032, 1987 Case IH 585 4wd, BCS 853 w/ 26" tires
A landscape rake is going to work best in my opinion. Once you get through the sod it will break up and move around dirt.
Rustyiron
Super Member
Tooth bar?