Berniep
Platinum Member
Can't wait to see the results
BX23 seems slow and weak
- Thread starter Tractor_Jim_CT
- Start date
tommu56
Elite Member
I just plugged it in to one of the loader lines and ran it till it hit end of stroke and read gauge right around 1800psi what they call for in the manual sure beats the $400.00 I found on line that did flow temp and pressure I think I have $75.00 in it.
The only problem I had was gauge rubbed hood so I couldn't leave it on while running it.
I will get a 45 degree el or a short hose to move it out of the way
tom
The only problem I had was gauge rubbed hood so I couldn't leave it on while running it.
I will get a 45 degree el or a short hose to move it out of the way
tom
Harry c
Gold Member
I unscrewed the Hydraulic hose from one of the QDs to the FEL and screwed in a high quality, fluid filled gage. Snapped the QD with gage back on, started the engine, pulled the lever and read the pressure. It was right at the recommended 1780 psi. Took the gage back out of the QD, re-attached the hyd hose and back in business. I had no real reason to check. Just curious I guess.