Anyone made their own ?
I was thinking of bending up some 5/8 or 3/4 re-bar - if I could get the pattern.
Angles probably matter and at a guess there are at least two planes in which the bends are made - and those have to be at the right angle to each other too.
Anyone discover the geometry from repairing one ?
tnx
Errr, maybe not 3/4 inch, but I could probably hack up a bender to do 5/8.
I was thinking of bending up some 5/8 or 3/4 re-bar - if I could get the pattern.
Angles probably matter and at a guess there are at least two planes in which the bends are made - and those have to be at the right angle to each other too.
Anyone discover the geometry from repairing one ?
tnx
Errr, maybe not 3/4 inch, but I could probably hack up a bender to do 5/8.