notrees
Member
- Joined
- Feb 10, 2013
- Messages
- 27
- Location
- Central Florida
- Tractor
- Bucket trucks, S300, Vermeer 502, Bandit 2890, gooseneck dumps, 2010 Ftx 148L with samurais, Kubota L2500
Hi everyone im new to the forum.. thanks to all that post here. I have gotten some really good info on previous conversations here. I have a rather large job that I should be signing the finals on in the next month or so and will need to purchase some mulching equipment. I think im pretty sold on the gyrotrac gt 13 as a track machine, and have found a very affordable low hour maching that I would like to have. I am considering the denis cimaf dah 080c to go on an excavator and was curious if anyone out there has operated one or has any advice on a comparable head. Also if anyone has any advice on the unit that will push the head the best. Im aware that both of these units are a little higher on the price chart but im a firm believer in productivity and quality construction. Sharpening the planer teeth daily is no conscern to me. I actually like the idea of having a fresh sharp edge instead of putting off replacing half dulled teeth. I had a case 90xt with steel over the tire tracks and a fecon head back in 2008 that i did a big prodject down in Bonita Springs with, and I am not totally new to the mulching scene, but 6 months of mulching in 08 makes me no pro either and alot has changed since then with technology. Any feedback would be appreciated. Thanks