I have 3015 series Branson and, am pretty sure, implement 3 point height control in the rear is about the same across most tractors. Lever control, up/down.
So here's my question.
I have Fred Kain ripper/scarifier and am trying to figure out, how to, possibly control how deep it goes in with shanks, with implement up/down tractor control. Is it possible somehow? I don't want shanks to go full depth in, I want them to go in maybe half the working depth of the shank arm.
So here's my question.
I have Fred Kain ripper/scarifier and am trying to figure out, how to, possibly control how deep it goes in with shanks, with implement up/down tractor control. Is it possible somehow? I don't want shanks to go full depth in, I want them to go in maybe half the working depth of the shank arm.